POOLTREE SYSTEM LLC

Replacement parts sold separately - COLORS MAY VARY - descriptions below:

Standard Ball: The PoolTree Ball is used to support the center of the PoolTree System holding the cover out of the water. Must be used with the standard harness (sold separately). Oversized ball upgrade available.

Standard Harness: The PoolTree Harness is used to attach the support lines to the ball and hold the ball in place.  Must be used with the standard ball (sold separately). Oversized harness upgrade available.

StretchConnect Coupler Assembly (Bungee Assembly): The StretchConnect Coupler Assembly (Bungee Assembly) is a 3-piece set that connects your pool to the harness and ball. It consists of a patented stretch bungee connector, strap and rope. These pieces are what allow the System to flex up and down under the weight of water and snow, therefore reducing stress on your pool. The tension of the StretchConnect Coupler (bungee) pulls the (mesh) cover out of the water when it gets weighed down, allowing it to dry and drain. The connectors are designed to hold the rope on one end attached to the ball harness and the nylon strap at the other end tying the system together.

StretchConnect Coupler (Single Bungee): Perhaps the most important component of the PoolTree System; the patented StretchConnect Coupler (bungee) is what allows the System to flex up and down under the weight of water and snow, therefore reducing stress on your pool.  The tension of the StretchConnect Coupler (bungee) pulls the (mesh) cover out of the water when it gets weighed down, allowing it to dry. The connectors are designed to hold the rope on one end and the nylon strap at the other, tying the system together.

Strap with Buckle: This strap is what attaches the PoolTree System to the upright support on the pool. The strap comes with a side release buckle for easy on & off. **Strap not rated for lifting.

Oversized Ball: This oversized (40") ball is approximately 35% larger than the original and holds the cover higher off the water. Comes standard in all PoolTree Systems for pools with spans larger than 30', but will benefit all pool sizes (must be used with the oversized harness - sold separately. 

Oversized Harness: This oversized (40") harness is approximately 35% larger than the original. The PoolTree Harness is used to attach the support lines to the ball and hold the ball in place. Comes standard in all PoolTree Systems for pools with spans larger than 30', but will benefit all pool sizes (must be used with the oversized ball - sold separately). 

Standard Ball Plug: Replacement ball plug for standard ball (75cm).

Oversized Ball Plug: Replacement ball plug for oversized ball (100cm).